Set up 

1)Installation of the cutter

 Installl the table to the cutter base with provided screws and bolts as shown.

Warning:Don't put our fingers againsts sharp edge  ofthe bladeat any time

2)Installation of the cutter

Fix the handle with the screws and wrench provided.

Warning:Do not put your fingers againsts the sharp edge of the blade at any time.

3)Cutting Preparation

1)Adjust the angle attachment to desired angle as needed.

2)The angle attachment can be used on left side of the tables as shown.

Waring:Do not out your fingers againsts the sharp edge of the blade at any time.

Next part Cutting 

Straight Cutting

1)Insert material between the cutting blade and the base,flush with the angle attachmentas shown and hold the material with foot then push handle down to complete a cut.

2)Blade cutting maximun width:240mm

3)Blade cutting maximum depth:10mm

Waring:Maintain control of the handle.Do not allow handle to slam back after making a cut.

  45 degree Cutting 

1)Swing the angle arrachment to 45 degree.Insert material between the cutting blade and the base,against attach

2)Blade cutting maximum width is 169mm when angle cut 45 degree

Warning:Maintain contro; of the handle.Do not allow handle to slam back after making a cut.

Maintenance

1. Changing the blade

2. Use the provided wrench to remove the five screws,then hold the blade by each end and carefully move the blade out 

Note:the flat side to the blade facing the table

Warning:Do not put your fingers against the sharpe edge of the blade.

 3.Carry.Close the latch on the cutter head and carry the cutter as shown.